TRANSMISSION

IDLER GEAR NEEDLE BEARING

Fitted with 3135X042 liners fully finished 100mm bore size.Plateau honed bore. Agricultural / Construction TURBO & NON TURBO applications Left hand mounted starter motor. Turbo charger drain holes and oil filter blanking plates may need to be removed from old engine and fitted to new. Fitted with Piston Cooling Jets. If not required, please remove and re-fit blanking screws and washers.

CIRCLIP 36 x 1.75mm

UNIVERSAL JOINT 24 x 62mm

POWER STEERING CYLINDER

OD: 47.1 ID: 34.9 Width: 18.5mm

UNIVERSAL JOINT 30.2 x 106.5mm

DRIVE SHAFT SEAL

SIDE SHAFT INNER BUSH

AXLE PIVOT PIN BUSH

AXLE PIVOT PIN BUSH

AXLE PIVOT SECURING PIN