ENGINE

Standard Big End Size 38.964 - 38.975mm Bearing Width 17.32mm

Length 65.20mm Small Outside Ø 25.4mm Large Outside Ø 26.70mm Small Inside Ø 22.20mm Large Inside Ø 23.50mm Must be rolled top and bottom with Churchill service tools LC.173 and LC.174 (not available). Should be fitted with EM9599 injector washer. If rolling tools are not available, EM9388 can be used in place of EM9598 which does not require rolling.

INJECTOR SLEEVE WASHER

OD: 32.40mm ID: 26.36mm Thickness: 3.02mm

Volts: 12 Amp: 4.5 Pressure: 50-70kPA Flow Rate: 145l/h

Stem: 6.9mm Length: 132.1mm Head: 36.3mm Angle: 30°

Stem: 6.9mm Length: 132.0mm Head: 33.5mm Angle: 45°

1100 SERIES CONNECTING ROD FOR LATER TYPE ENGINE WITH SGI CRANKSHAFT WITH BIG END SIZE 67.99mm (2.6768 inch). BIG END BOLTS M10 TORX HEAD SCREWS. LENGTH GRADE 'R' (165.728 to 165.761mm) SEE MEASUREMENT 'Y' FOR LENGTH

1100 SERIES CONNECTING ROD FOR LATER TYPE ENGINE WITH SGI CRANKSHAFT WITH BIG END SIZE 67.99mm (2.6768 inch). BIG END BOLTS M10 TORX HEAD SCREWS. LENGTH GRADE 'O' (165.682 to 165.715mm) SEE MEASUREMENT 'Y' FOR LENGTH

1100 SERIES CONNECTING ROD FOR LATER TYPE ENGINE WITH SGI CRANKSHAFT WITH BIG END SIZE 67.99mm (2.6768 inch). BIG END BOLTS M10 TORX HEAD SCREWS. LENGTH GRADE 'W' (165.637 to 165.670mm) SEE MEASUREMENT 'Y' FOR LENGTH

1100 SERIES CONNECTING ROD FOR LATER TYPE ENGINE WITH SGI CRANKSHAFT WITH BIG END SIZE 67.99mm (2.6768 inch). BIG END BOLTS M10 TORX HEAD SCREWS. LENGTH GRADE 'G' (165.591 to 165.624mm) SEE MEASUREMENT 'Y' FOR LENGTH

1100 SERIES CONNECTING ROD FOR LATER TYPE ENGINE WITH SGI CRANKSHAFT WITH BIG END SIZE 67.99mm (2.6768 inch). BIG END BOLTS M10 TORX HEAD SCREWS. LENGTH GRADE 'P' (165.545 to 165.578mm) SEE MEASUREMENT 'Y' FOR LENGTH